Filter
Top Products
3
10
MIX'N MACHINE
PARTS LIST
PARTS LIST
Diagam# Q Deciwion Pa o
Iem#
M1 1 Stainless Steel Frame A S Y-
801
M2 1 Induction Motor (120 V) with Capacitor A S Y-
800
M4 1 Cap PLS-801
M6 2 Jumper Wires W I R-
801
M7 3 Cap Retaining Screws FST-801
M8 1 Snap in Rocker Switch C T L-
800
M9 1 5 Amp Circuit Breaker (120 V) C T L-
801
M10 1 Cord - U.S. W I R-
800
M11 1 Right Angle Strain Relief C ON-
800
M12 4 Motor Mounting Screw FST-800
M13 1 Slinger D DR-
800
M23 1 Front Label LBL-833
M24 4 Pivot Pin FST-803
M25 4 Pivot Pin Mounting screws FST-804
M30 1 Moving Sliding Splash Guard Cup PLS-836
M33 8 Fasteners FST-804
M34 1 Top Cover - wall mount STM-811
M35 1 Base - wall mount STM-813
M36 3 Front Label - wall mount LBL-834
M37 1 Agitaor Shaft Extension-wall mount SCM-807
M38 1 Vibration Damper Pad RBB-805
6. Moving Splash Guard: Made out of NSF and FDA Certied polycarbonate
material, it moves up and down along with the cup, catches food material thrown
from the agitator wall over all 360˚, inhibits throw out at the top, and thus keeps
the inside of Mix'n Machines and counter tops cleaner as well as (for wall mount
units) protecting the whole working area. Also, it is a built-in cup limiter which
prevents agitators from going through the bottom of cups. It is easily removed
for cleaning. You may want extra sliding splash guard cups to keep a clean
machine all the time. The sliding splash guard snaps onto the ends of the rods.
When mixing, this splash guard sits on top of the cup collar and rides up and
down with your motion. It prevents splash from the top when mixing and it
catches spin off from the agitator when it drops back into its resting position.
The splash guard is easily removed for cleaning.
The splash guard serves as a cup limiter to protect the bottom of 16 oz. cups
with disposable collars from penetration with mixing spoons. The spacer tubes
(2 enclosed) can be slid on the rods just above the sliding splash guard. These
t snugly on the rods and stay in place when cleaning. With these tubes in place,
the splash guard serves as a cup limiter for 12 oz. cups with disposable collars.
Simple spacer tubes of other lengths on the sliding rods can be used to protect
other smaller cups.
7. Frame: It is a simple, strong stainless steel design with splash area joints sealed
and internal radii provided.
8. Foot Control: A grounded foot control may be purchased for easy one-handed
operation. (optional)
9. Warranty: You get a ve year limited parts only warranty - see warranty
description on page 12 of this booklet for full details.
10. Wall mount Mix'n Machine: This is also a simple, strong stainless steel design
available only with moving splash guards. This unit can be mounted on the side
of a cabinet or on the wall, saving counter space.
11. Wall mount drip pans available: To catch dripping from agitators of wall mount
Mix'n Machines. These drip pans are easily removed for cleaning.
12. Moving splash guard Mix'n Machine: This is similar to the Standard Mix'n
Machine except it comes with the moving splash guard which functions as a
built-in cup limiter as well as keeps the inside of the housing cleaner.