Filter
Top Products
9
English8 English
Positioning Your Circulator
1. Position your Tower Circulator so the airstream has an unobstructed
path from one side of the room to the other, or position the
airstream to blow directly at you for direct cooling.
2. Set to a medium speed and allow a few minutes for an airflow
pattern to be established. (Different airflow patterns can be
established by changing the location, and speed of the Tower
Circulator.)
3. Adjust the speed accordingly until a desired comfort level is
achieved. You will quickly determine the precise amount of
circulation required to maintain your personal comfort in a given
room for the prevailing temperature and humidity conditions. Once
you discover the added comfort of air circulation, you will use your
Vornado Tower Circulator season after season.
How To Use
Placement near a wall or corner
Please position at least 6” away
from walls or other large surfaces.
Doing so will ensure your Tower
Circulator has adequate room
to intake air, providing optimum
performance. (See Figure A)
Directing the airflow
Unlike any other tower
fan, this product creates a
wide span of airflow called
V-Flow™ Circulation. The
Vornado logo indicates
the center point of the
V-Flow™ airstream, and
can be used as a reference
point for positioning the
product in the room. (See
Figure B)
6”
6”
Figure A
Figure B
Power (A) The unit functions ON and OFF by pressing the
POWER button. Lights on the unit’s control panel indicate the
power is ON.
Fan Speed (B) The fan speed can be adjusted by pressing the
SPEED button. Press the button to switch between the unit’s
speed settings. The turbo (highest) setting is for maximum
air circulation. Lights on the unit’s control panel indicate the
selected speed setting.
Timer (C) The unit has an automatic timer to turn the unit OFF
at intervals of 1, 2, 4 or 8 hours. To set the timer, turn the unit
on and select desired speed. Press the timer button until the
desired run time light is illuminated. The unit will continue to
run until that amount of time has expired.
Controls
Remote Control This unit comes with a remote control. The
remote control functions are the same as the control panel on
the unit. The remote requires a line-of-sight path to allow for
the signal to be received by the unit. Position the unit so the
receiver lens (located above the Vornado logo) is visible from
the remote control. The remote control can be stored with
the Tower Circulator using the magnetic bowl-shaped cradle
located on the top of the product.
Remote Control Battery The remote control comes with a 3
Volt lithium coin cell battery (CR2032). To install, remove the
battery cover on the bottom of the remote control. Remove any
plastic protection from the battery and place it in the remote
with the + side facing out. Then reposition the cover onto the
bottom of the remote. If your remote does not work, please try
replacing with a new 3 Volt CR2032 battery.
1 4
3
2
A
B
C