Filter
Top Products
— 8 —
USING THE FRYER (After Startup)
1. Load the fry basket(s); do not overfill.
2. Carefully lower basket(s) into shortening.
3. Press
to start the left timer. Press to start the right timer.
4. When the timer times out, a beeper sounds. Press
to silence the left timer beeper. Press
to silence the right timer beeper.
NOTE: To cancel the timer after countdown has started, press and hold
or for at least 3
seconds.
SHUTDOWN
1. Press the power switch OFF.
EXTENDED SHUTDOWN
1. Press the power button OFF.
2. Drain the fryer.
3. Turn the main electrical supply line OFF.
Melt Options (1ERD Series)
The controller has three options for bring shortening up to temperature:
CY L (Liquid shortening) - For slowly bringing liquid shortening up to temperature.
CY S (Solid shortening) - For slowly melting solid shortening.
CY O (No melt) - For immediately bringing liquid shortening up to fry temperature.
When using solid shortening in the fryer, the CY S (solid shortening) option must be used. Solid
shortening must be gently warmed to a liquid state before heating to frying temperatures. Melting solid
shortening without using this option will damage the fry tank and scorch the shortening.
1. Remove crumb screens from fryer tank.
2. Lift elements out of each tank area.
3. Chop the solid block of shortening into pieces that can be packed into the bottom of fryer tank.
4. Pack bottom of the tank with shortening chunks.
5. Lower elements back into tank.
6. Pack the remaining chunks of shortening completely around and over top of the elements, then
place the screen on top of the shortening.
Upon startup, if the CY L or CY S melt option is selected and the shortening temperature is below 135°F
(57°C), CY is displayed in the window and the fryer cycles to bring the shortening up to temperature.
If the shortening temperature is over 150°F (65°C), HEAT is displayed in the window and the fryer
quickly heats up to set temperature.
The temperature is displayed in the window when the fryer has reached the set temperature. After the
first initial startup, the fryer always defaults to the last entered melt option.
To display the actual temperature at any time, press
and hold for 3 seconds. Press again to
return display to set temperature.