Filter
Top Products
34
3. Support box with one hand on the under side and remove box from the cooker. (Fig. 48)
Note that you may need to lift the box up slightly to remove it from the slide track.
Fig. 48
4. Reinstall box by reversing steps 1-3. Be sure to align the scrap box drain tube into the scrap box housing
tube in the rear of the cooker.
REMOVAL OF HOT AND COLD WATER FILL VALVES AND FITTINGS
1. Follow steps 1-5 under removal of control panel.
Note: When hose fittings are removed check to insure that the hose washers are in good condition. If they
are cracked or worn looking, replace the washer before reinstalling hose. Remove hose fittings.
2. Disconnect (4)
5
⁄16 holding screws and (2) holding bracket. (See Fig. 14)
3. Remove the fitting assembly made by a
1
⁄2" tee and (2) elbows
4. Install new fittings by reversing steps 1-3 .
REMOVAL OF REAR DRAIN COUPLING
1. Empty discard container completely.
2. Disconnect the cooker/drain station and move it away from the floor drain in an area assessable to the rear
of the appliance.