Filter
Top Products
MODEL C24EA - STEAM GENERATOR TANK
F25213 (May 2006) Page 34 of 52
STEAM GENERATOR TANK
WARNING: DISCONNECT THE ELECTRICAL POWER TO THE MACHINE AND FOLLOW
LOCKOUT / TAGOUT PROCEDURES.
REMOVAL AND REPLACEMENT
1. Turn off machine to drain steam generator tank.
Allow steamer to complete drain cycle.
A. Turn off water supply.
2. Remove the TOP COVER, RIGHT and REAR
PANEL as outlined under COVERS AND
PANELS.
3. Disconnect electrical wiring then remove HOLD
THERMOSTAT.
4. Disconnect the fill union fitting.
NOTE: It is not necessary to disconnect the electrical
wiring to the motorized drain valve in order to
remove the motor section of valve.
5. Remove the drain valve controlling mechanism.
A. For Pro models, refer to MOTORIZED
DRAIN VALVE and remove the motor
section of valve.
B. For Basic models, refer to MANUAL
DRAIN VALVE and disconnect the linkage
from valve. Remove the on/off power
switch and bracket as an assembly.
NOTE: Water level probe assembly is to be removed
from the steam generator tank once the steam
generator is removed from the steamer.
6. Disconnect the drain flush solenoid hose and
drain hose from the Tee located below the drain
valve.
7. Disconnect steam outlet hose from tank fitting
or super heater fitting (super heater on
Professional model only).
8. Remove HEATING ELEMENT.
9. If Pro model, disconnect the super heater
electrical wiring.
A. Remove the super heater element and
super heater housing as an assembly at
the top machined elbow.
PROFESSIONAL MODEL SHOWN