Filter
Top Products
Fig. 8
5. Lift the control bracket up and tilt forward to
remove bracket from mounting screws.
6. Partially install the grease drawer leaving enough
of the drawer extended to support the control
bracket while servicing.
Fig. 9
7. Griddle controls are now accessible for removal.
A. If replacing control bracket, remove screws
securing griddle controls to bracket.
B. Remove manifold cover brackets (L & R)
from each end of the control bracket as
necessary (2 screws for each bracket).
8. Reverse procedure to install and check for proper
operation.
STANDARD OVEN PILOT
ASSEMBLY AND THERMOCOUPLE
Shut off the gas before servicing the
unit.
All gas joints disturbed during
servicing must be checked for leaks. Check with a
soap and water solution (bubbles). Do not use an open
flame.
1. Remove bottom oven rack(s) and rack guides.
2. Remove cavity bottom by lifting up and sliding
out.
3. Remove screws securing oven pilot assembly to
burner carrier.
Fig. 10
4. Lower the KICK PANEL (24" & 30" OVENS).
5. Pull oven pilot assembly out through opening in
lower oven frame.
6. If replacing thermocouple only, remove
thermocouple from oven pilot assembly and gas
safety valve. Continue to last step.
When installing, do not bend and kink the
capillary tube or damage to the component may occur.
7. If replacing oven pilot assembly, remove pilot
tubing and thermocouple from oven pilot
assembly.
8. Reverse procedure to install and check for proper
operation.
STANDARD OVEN BURNER
Shut off the gas before servicing the
unit.
All gas joints disturbed during
servicing must be checked for leaks. Check with a
soap and water solution (bubbles). Do not use an open
flame.
1. Lower the KICK PANEL (24" & 30" OVENS).
2. Hold the tab on burner carrier with plyers to
support it then remove compression nut from
burner elbow fitting to disconnect gas supply
tubing.
3. Remove screws securing burner carrier to oven
frame.
ENDURANCE / CHALLENGER MODULAR SERIES GAS RANGES - REMOVAL AND REPLACEMENT OF PARTS
F45471 Rev. A (0615) Page 8 of 38