Filter
Top Products
5 F-38251 (09-13) REV F
RCCONRL-(24,36,48,60,72)
Condiment Rail Assembly - Replaces standard bullnose.
Available for 24", 36", 48", 60", and 72" ranges. (Does not
include condiment pans)
SHIELD-FRYRH
SHIELD-FRYLH
Fryer Splash Shield - Right hand or left hand side. Protects
range top against grease splatter from adjacent fryer.
VFLANGED-FEET/4
Set of four (4) flanged feet. Two (2) sets required for 48", 60",
and 72" ranges.
CURBMNT-XL4
Curb mounting kit. Two (2) sets required for 48", 60", and 72"
ranges.
INSTALLATION
UNPACKING
This range was inspected before leaving the factory. The transportation company assumes full
responsibility for safe delivery upon acceptance of the shipment. Immediately after unpacking, check for
possible shipping damage. If the range is found to be damaged, save the packaging material and contact
the carrier immediately.
Remove all shipping bands, blocking, and packaging. Remove the high shelf, and backsplash assembly.
Before installing, verify that the electrical service agrees with the specifications on the rating plate located
behind the kick panel on the left side. If the supply and equipment requirements do not agree, contact your
dealer or Vulcan-Hart immediately.
If it is required to remove the door and install it for access through a kitchen door, follow the instructions
below.
Door removal
1. Open door.
2. Grasp door firmly at both sides.
3. Lift door upward and pull it out so bottom hinge tab disengages.
* This may be easier to accomplish one side at a time.
4. Close door almost shut and lower slightly to disengage top hinge tab.
5. Pull door outward.