Filter
Top Products
– 5 –
Assembling the Legs to the Single Oven
The 4" (10 cm) or 6" (15 cm) legs are packed inside the oven during shipment and must be installed on the
bottom of the oven. Place the oven on its left side, being careful to avoid scratching the finish. The gas pipe
connection protrudes beyond the back; provide for this when oven is tipped back by resting it on suitable
spacers (2 x 4's etc.). Thread each of the four leg assemblies into the holes provided on the bottom corners
of the oven. Carefully raise the oven to its normal upright position.
Assembling the Chimney to the Single Oven
Remove the chimney from inside the oven cavity and use the screws
provided to fasten the chimney to the top rear of the oven (Fig. 2). The
flanges on the chimney are to be positioned over the top cover.
Assembling the Oven to the Stand
Position the oven on its back, taking care not to scratch or damage it. The
gas pipe connection protrudes beyond the back; provide for this when the
oven is tipped back by resting it on suitable spacers (2 x 4's). Install the
two locating studs (included in the stand carton) into the screw plates on
the underside of the oven (Fig. 3).
Attach each of the four leg assemblies to the bottom of the stand with the
12 bolts and lockwashers (3 per leg). If casters are used instead of legs,
put fixed casters in rear and swivel casters in front using 12 bolts and
lockwashers (3 per caster). Mount the oven on top of the stand.
Assembling Stacked Ovens
Determine which oven will be on the bottom and place it on its left side,
being careful to avoid scratching the finish. Install the four 16
3
/4" (42.5 cm)
legs, using the 24 bolts and lockwashers provided (6 per leg). Remove the
two
7
/16" (1.1 cm) knockouts on each side of the top cover and place oven
in upright position at installation location. Turn the adjustable feet in or out
to level the oven front-to-back and side-to-side (refer to LEVELING, page
6).
Remove right side panels from both ovens. Remove welded plate from
bottom of upper oven (Fig. 3). Install the two locating studs (included in the
leg stack set) into screw plates on underside of upper oven (Fig. 3). Place
upper oven on top of lower oven using the locating studs.
Remove flue extension from upper oven. Install long flue extension into
existing right-angled flue extension in lower oven. Attach long flue extension
to wall of upper oven using screws provided. Secure chimney to roof of
upper oven (Fig. 4).
Install right side panels on both ovens. Connect the piping between the top
oven and bottom oven. Pipe joint compound must be resistant to the action
of propane gases.
The manual gas valve at the bottom of the control panel should remain off
until all electrical connections are made and the ovens are checked or
used.
CHIMNEY
PL-52240
Fig. 2
REAR OF TOP OVEN
KNOCK OUT WELDED PLATE
FOR FLUE EXTENSION INSTALLATION
BOTTOM
LOCATING STUDS
PL-52992
FRONT OF TOP OVEN
Fig. 3
Fig. 4
RIGHT ANGLED
FLUE EXTENSION
LONG FLUE
EXTENSION
CHIMNEY
PL-52221