Vulcan-Hart GDC48 ML-52583 Cooktop User Manual


 
— 3 —
Installation, Operation and Care of
GDC SERIES GAS DUPLEX COOKERS
KEEP THESE INSTRUCTIONS FOR FUTURE USE
GENERAL
The GDC Series Gas Duplex Cookers combine a high efficiency gas griddle with adjustable-height,
thermostat-controlled electric platens to provide fast production of grilled foods. Vulcan Duplex
Cookers are produced with quality workmanship and material. Proper installation, usage and
maintenance will result in many years of satisfactory performance.
It is suggested that you thoroughly read this entire manual and carefully follow all of the instructions
provided.
INSTALLATION
Before installing, verify that the type of gas (natural or propane), the elevation, and the electrical service
agree with the specifications on the rating plate, located on the left side panel.
UNPACKING
This cooker was carefully inspected before leaving the factory. The transportation company assumes
full responsibility for safe delivery upon acceptance of the shipment. Immediately after unpacking,
check for possible shipping damage. If the cooker is found to be damaged, save the packaging material
and contact the carrier within 15 days of delivery.
CAUTION: Lower all platens before attempting to move this cooker.
LOCATION
The installation location must be kept free and clear of combustibles. Clearances from combustible
and non-combustible construction must be a minimum of 7 inches from the sides and 2 inches from
the back. A minimum front clearance of 32 inches is required for service and operation.
Sufficient air should be allowed to enter the room to compensate for the amount of air removed by any
ventilating system and for combustion of the gas burners. Do not permit fans to blow directly on the
cooker. Avoid open windows at the sides or back. Avoid wall-type fans which create air cross currents
within the room. Do not obstruct the air flow into and around the cooker. Do not obstruct the flow of
flue gases from the flue duct (when so equipped). It is recommended that the flue gases be ventilated
to the outside of the building through a suitable and properly installed ventilation system.