Filter
Top Products
-
20 -
ACCESSORIES
GTS12 ELECTRIC GRIDDLE TEFLON WRAP KIT INSTALLATION
The griddle and its
parts are hot. Use care when
operating, cleaning or servicing the
griddle.
1. Clean off platen using soft cloth, water
and mild soap solution.
2. Slide the Teflon bracket (#944503) into
the sleeve of the Teflon sheet as shown in
fig. 20.
4. Raise the platen to the 47° locked
position. Drape the Teflon sheet
(#944505) from the right side of the
platen by hooking the front and back of
the Teflon bracket to the Teflon retaining
pins. See fig. 21.
5. Pull the Teflon sheet from the right side
around the face of the platen cooking
surface to the left side.
6. Pull the Teflon sheet tight and ensure the
cooking surface of the platen is completely
covered by the Teflon sheet.
7. Secure the Teflon sheet to the left side of
the platen with the two Teflon clips
(#944504). See fig. 22.
GTS12 units that were shipped
before March 2013 utilize a different Teflon sheet
(#498852-1) and mounting system (two bars
#498852-2 and three springs 498852-3).
CARE AND CLEANING OF TEFLON WRAP
1. In between cooking runs and during idle
Periods, the Teflon sheet should be wiped
off with water and a clean soft cloth.
2. After each day the Teflon sheet should be
removed from the platen(s), disassembled
and placed in water with mild soap
solution (no abrasive or harsh chemical
cleaners should be used). Gently wash
both sides of the Teflon sheet and the
hardware with the soft clean cloth in the
mild soap solution.
Fig. 20
Teflon Bracket
Teflon Sheet Sleeve
Teflon Retaining Pin
Fig. 21
Fig. 22
Teflon Clip