Filter
Top Products
GEARBOX (TILT MODELS ONLY)
Disconnect the
electrical power to the machine and
follow lockout / tagout procedures.
1. Place a pallet jack under the kettle of the unit.
NOTE: Place pallet jack under kettle and not under
the tubular frame.
NOTE: Place 2x4 or 4x4s on the pallet jack if needed
to reach the bottom of the kettle.
2. Remove CONTROL BOX COVER.
3. Note location of wiring and remove element,
pressure switch wires and unplug the sensor
plug.
Fig. 22
4. Remove the four bolts holding the gearbox to the
component box.
5. Lift the kettle just high enough to slide the
gearbox off of the shaft and clear the component
box lip.
NOTE: Be careful not to damage the wiring as you
remove gearbox from shaft.
6. Remove the positive stop plate assembly from
the old gearbox and install it on the new one.
Fig. 23
7. Install new gearbox in kettle.
8. Lower the gearbox until it touches component
box housing.
NOTE: Only lower the gearbox enough to align the
holes and bolt the gearbox down.
9. Lower the kettle and remove pallet jack.
10. Connect the wiring.
11. Check operation of kettle.
TILT BEARING
Disconnect the
electrical power to the machine and
follow lockout / tagout procedures.
1. Place pallet jack under kettle.
NOTE: Make sure pallet jack is under kettle and not
under the tubular frame.
NOTE: Place 2x4 or 4x4s on the pallet jack if needed
to obtain the proper height.
2. Loosen set screws on bearing assembly.
Electric Stationary and Tilting Kettles - REMOVAL AND REPLACEMENT OF PARTS
F45472 (1112) Page 12 of 29