Filter
Top Products
— 10 —
ELECTRIC STATIONARY KETTLES
PLUG VALVE CLEAINING
INSTRUCTIONS
Daily Before Operation
Install draw off valve plug:
1. Apply PetroGel lubricant to valve tapered
face.
2. Holding the valve handle, slide the plug
down into the valve body.
3. Install the bottom washer, making sure to
align the key with the groove in the valve
plug.
4. Install the retaining ring and hand tighten.
NOTE: If the valve is hard to open the ring has
been overtightened.
Daily After Use
Remove draw-off valve plug for cleaning.
1. Unscrew the retaining ring and remove it
and the bottom washer.
2. Pull the valve plug straight up to remove
from valve body.
3. Wash valve body, plug, washer and
retaining ring with mild soap and water.
4. Leave assembly apart to air dry.
NOTE: 1. Care should be taken not to
scratch, ding or dent the valve
plug to prevent valve leakage.
2. If multiple kettles are in use care
should be taken keep each plug
separate and returned to its
original valve body.
Valve Plug
Valve Body
Bottom Washer
Retaining Ring
Fig. 7 Plug Valve