Filter
Top Products
— 5 —
ELECTRIC STATIONARY KETTLES
INSTALLATION
LOCATION
Stationary Kettle
Position the kettle in its final location. Check that
there are sufficient clearances for operating and
servicing the kettle, and proper clearance of the
cover when raised. The kettle draw-off valve
should be located near a floor drain.
Tilting Kettle
Position the kettle in its final installed location to
provide drainage directly below pour path, with
sufficient rear clearance from the wall to allow
the kettle to tilt completely without obstruction.
UNPACKING
This kettle was inspected before leaving the
factory. The transportation company assumes
full responsibility for safe delivery upon
acceptance of the shipment.
Immediately after unpacking, check for
possible shipping damage. If kettle damage is
found, save the packaging material and
contract the carrier within 15 days of delivery.
INSTALLATION CODES
AND STANDARDS
In the United States, Vulcan kettles must be
installed in accordance with:
1. State and local codes
2. NFPA Standard NFPA-96, Vapor Removal
from Cooking Equipment, latest edition,
available from the National Fire Protection
Association, Batterymarch Park, Quincy,
MA 02269
3. National Electrical Code (ANSI/NFPA
No.70, latest edition) available from the
National Fire Protection Association
(NFPA), Batterymarch Park, Quincy, MA
02269
In Canada, Vulcan kettles must be installed in
accordance with:
1. Local codes
2. Canadian Electrical Code (CSA C22.2
No.3, latest edition) available from the
Canadian Standards Association, 5060
Spectrum Way, Mississauga, Ontario,
Canada L4W 5N6