Filter
Top Products
Kettle Fully Tilted - Traveller Contacts Stop Plate
3) Turn crank handle clockwise to tilt the
kettle. The kettle should be tilted past
90° to empty its contents. The
adjustment range is 92 to 95 degrees.
4) Turn positive stop traveller on the
positive stop shaft (threaded) until it
contacts the stop plate.
5) Adjust position of positive stop traveller
as needed to align the shoulder screw
mounting hole to the threaded hole in
stop plate. Install shoulder screw.
6) Turn crank handle to verify operation.
Repeat adjustment as necessary.
7) Install tilt switch bracket.
7. Install control panel cover.
TILT SWITCH (2S) ADJUSTMENT -
POWER TILTING OPTION ONLY
Fig. 49
1. Remove CONTROL BOX COVER (TILTING) to
access Tilt Switch (2S).
2. Kettle tilt operation - The switch actuator should
be operated by the arm when the kettle is fully
upright to open the N.C. contacts and stop travel.
3. If adjustment is necessary, loosen the tilt switch
mounting bracket screws (2) and position the
switch to obtain the proper tilt switch operation.
The mounting bracket holes are slotted to allow
for adjustment.
A. Kettle fully upright - Tilt switch should be
operated (N.O. held closed).
B. Kettle tilted approximately 10 degrees - Tilt
switch should be un-operated to remove
power from control circuit through the N.O.
contacts. The N.C. contacts should be
closed to energize K3 and allow kettle to be
raised when tilt motor switch is operated.
4. Tighten switch mounting bracket screws and
check for proper operation.
K Series Gas Kettles 2/3 Jacketed Stationary and Tilting - SERVICE PROCEDURES AND ADJUSTMENTS
Page 27 of 44 F45461 Rev. A (0713)