Filter
Top Products
REMOVAL AND REPLACEMENT OF PARTS
CONTROL BOX COVER (TILTING)
Disconnect the
electrical power to the machine and
follow lockout / tagout procedures.
NOTE: Remove screws from cover where indicated.
NOTE: On kettles with manual tilt or power tilt option,
the control box height is now taller (as shown) to
acomodate additional tilt components. The cover is
held in place using the same number of screws.
K20GLT Manual Tilt Shown
CORNER & REAR PANELS
(TILTING)
Disconnect the
electrical power to the machine and
follow lockout / tagout procedures.
NOTE: Remove screws from panel where indicated.
K20GLT Manual Tilt Shown
SIDE & REAR PANELS
(STATIONARY)
Disconnect the
electrical power to the machine and
follow lockout / tagout procedures.
NOTE: Remove screws from panel where indicated.
K20GL Shown
K Series Gas Kettles 2/3 Jacketed Stationary and Tilting - REMOVAL AND REPLACEMENT OF PARTS
Page 7 of 44 F45461 Rev. A (0713)