Filter
Top Products
– 7 –
Fig. 1
4. Rest the griddle plate in a secure place.
5. Thermostatically controlled griddles are shipped without the thermostat bulb in the “V” shield.
The bulb must be installed by the installer to prevent damage to the griddle and the thermostat
(not covered by the warranty). Exercise caution when placing brick in a thermostatically
controlled griddle section. DO NOT hit thermostat bulb while installing bricks. The thermostat
bulb is a sensitive device and may be easily knocked out of adjustment.
Into the 6
1
⁄2" (16 cm) wide baffle, install:
a. Two 10" x 4" (25 cm x 10 cm) bricks, placing the miter edge, one to each side of the front
burner baffle area (Fig. 1).
b. Two 7" x 4" (17 cm x 10 cm) bricks, one to each side of the rear burner baffle
area (Fig. 1).
6. Into the 9
7
⁄8" (24 cm) wide baffle, install:
a. Two 10" x 4" (25 cm x 10 cm) bricks, placing the miter edge, one to each side of the front
burner baffle area (see Fig. 1).
b. Two 7" x 4" (17 cm x 10 cm) bricks, one to each side of the rear burner baffle area
(see Fig. 1).
7. If the burner has been strapped down, use wire cutters to remove the wire strapping
device.