Vulcan-Hart ML-044937 Oven User Manual


 
5
Product Features and Descriptions (Cont.)
SNORKEL CONVECTION OVEN - Rated at 30,000 BTU/hr. The interior dimension is 26
1
/4" wide x 23 deep and
14" high. The oven cavity is fully porcelainized. The door is also counterbalanced. Three oven racks are supplied
and the rack guides have four positions. The thermostat is a snap action KX type with a temperature range of
200°F to 500°F degrees. There is a
1
/4 HP fan motor that requires 115 Volt minimum 15 amp service.
LEGS/CASTERS - Standard units are supplied with four 6" legs. For curb installation, leveling bolts are available.
Casters are available with 3" or 5" diameter wheels. Legs, casters or curb bolts are all
5
/8" x 11 stems.
BACK RISERS - The standard unit is equipped with a 6" stainless steel stub riser. Also available are single and
double-deck risers with or without shelves and reenforced high shelves capable of mounting a Cheesemelter or
Salamander broiler. Another option is 48", 60" and 72" back risers in the same configurations capable of spanning
more than one unit. These wider back risers are special order only. All back risers are attached to the units via
a 2" x 4" female receiver on the top rear of the chassis and all high shelves/stub risers are interchangeable.
EXTERIOR FINISHES - The standard finish is black powder coat paint. All chassiss are powder coated prior to
assembly. The most common exterior finish is stainless steel on the front. Stainless steel sides are available as
an option. Cast-iron open burners and grates are painted with a light coat of water based enamel. The water-based
enamel is intended to protect the raw cast iron during transit and storage only. Cast iron hot tops and steel griddle
plates are coated with a USDA-approved oil that must be removed prior to operation.
SPREADERS - These are non-functional items that are designed to offer a work surface between appliances and/
or a place to locate a pressure regulator in a battery line up. The standard spreader comes with the continuous gas
manifold, back riser and a top surface only. A front apron is available.
GAS CONNECTIONS - The standard unit is supplied with a 1
1
/4" front manifold with a male union fitting on the
left side of the appliance, and the female union fitting is on the right side of the appliance. As an option, a rear gas
tailpipe connection is available in either 1
1
/4" or
3
/4". Also this rear gas connection can be used to interconnect a
cheese melter or salamander broiler that is mounted to the re-enforced high shelf. Manifold caps and cover plates
are available for stand-alone units or battery end units.
MISCELLANEOUS and SPECIALS - There are many other configurations available in the Signature line including
models for back-to-back island installations. Special wide and/or long bull noses to span up to 108" in length and
8
3
/4" in width. Additionally, back risers can be special ordered to span up to 72" in width.
Whenever dealing with any unit or configuration that seems unfamiliar, always secure the serial numbers and relay
that information to the factory for the specifics of the appliance.
Also available in the Signature line are double-stacked standard ovens, fryers, pasta cookers, single and double-
deck top-fired broilers and refrigerated bases. Only Vulcan-Hart Cheesemelters and Salamander broilers can be
mounted to the Signature line.