Filter
Top Products
– 6 –
Fig. 2
ELECTRICAL DATA
*50A if cord connected.
START-UP TESTING
After the oven is connected to the supply circuit, perform the following tests to ensure that the oven is operating
properly.
Lamp Test
Turn the oven on by pressing the ON/OFF button. After a few seconds, the display will settle on Recipe 1. At
this point, hold down the 1 button and push the 8 button at the same time. The display will appear as follows:
Would You Like To
Check The Lamps
1 = Yes 2 = No
"Stinger" Location
Ground
Ground
Receptacle
3 PHASE 240 VOLT RECEPTACLE
PL-52644
ledoMegatloVesahPselcyC
.xaM
rewoP
.xaM
tnerruC
lacipyT
rewoP
lacipyT
tnerruC
rekaerB
eziS
AMEN
-atpeceR
elc
21BFV042/802106Wk9.11A65Wk9A34A06R06-41
21BFV042/802306Wk9.11A53Wk9A72*A0405-51