Filter
Top Products
– 19 –
Approved Cleaning Materials and Procedures
Cleaners
• Mild dish soap - Use any mild food service type dish soap for the interior cleaning. Be sure that the soap
is non-caustic.
• Citrus 2000 Multi-Purpose Ready To Use
• Pro Formula 409 - Use for interior walls.
• Windex Powerized Formula - Use for cleaning the door window interior and exterior.
• Norcross Bar-Be-Que and Grill Cleaner - Use this to clean the stainless steel grill. Be sure the grill is only
cleaned when it is out of the oven.
• FDA food quality sanitizer for cooking surfaces.
Cleaning Tools
• Terry towel cloth - Food service quality.
• Non-abrasive pad - Institutional quality-certified non-abrasive. (Example: White 3-M).
• Small wire brush - Used to clean the rollers on the grill assembly only.
•
Flash
Bake lamp shield scraper.
Always rinse cleaned surfaces to ensure all the soap and chemicals have been removed, then wipe dry with a
soft clean cloth.
It is recommended that you clean the oven after each shift. If your operation is extremely busy, it may be
necessary to wipe out the oven during a shift until you are able to perform the detailed cleaning.
1. Allow oven to cool before starting the cleaning process.
2. Lift the door to the UP position.
3. Remove the grill and set aside. Clean the stainless steel grill with a non-caustic grill cleaner, using a small
wire brush. The grill MUST be cleaned only when it is out of the oven.
4. To start the interior cleaning, use a cloth dampened with one of the recommended cleaners. Be sure that
the soap is non-caustic. Wipe the food debris out of the oven, working from the back forward. Do not pour
cleaning liquids into the oven. Always use a cloth dampened with the cleaning fluids.
5. Using a
Flash
Bake lamp shield scraper, scrape the lower lamp shield to loosen all residual food. Repeat
step 4 by wiping the cavity out, working from the back forward.
6. Remove the upper lamp shield and clean as recommended in REMOVING AND INSTALLING THE TOP
LAMP SHIELD on page 20.
7. Dampen a clean cloth with one of the recommended cleaners and wipe out the interior wall surfaces to
remove any grease or spatters. Work from the back of the oven forward. Repeat this step several times
if necessary.
8. Next, use a small wire brush to clean the drive rollers. Make sure you remove any build-up so the rollers
spin freely. After brushing, clean the rollers with a mild soap and water solution. Rinse thoroughly and dry
with a soft clean cloth. Test the rollers by spinning them. The drive roller on the right side in the center of
the oven cavity will not spin by hand.
9. Clean the interior surface of the front door with a terry cloth towel and recommended cleaner. Wipe the
exterior edges of the door and frame, paying close attention to the gasket.