Vulcan-Hart SCB72 Oven User Manual


 
-
7 -
The charbroiler is a free vented appliance. All products of combustion and the heat
generated by the burners pass through the grates. When meat is placed on the grates,
this blocks the venting and causes a temperature build-up. The charbroiler operates most
efficiently with valves turned down to
1
/
3
or ½.
LIGHTING THE GAS PILOT (Fig. 3)
1. Turn the individual burner gas valves
off and wait 5 minutes.
2. Remove the Top Grates. Turn the
incoming main gas supply valve on.
Light pilots using a taper (Fig. 3).
3. To light the burners, turn the individual
burner valves on.
Fig. 3
TO COMPLETELY SHUTDOWN THE BURNERS AND PILOT LIGHTS
For complete shutdown: Turn the main gas supply valve off. (Make sure all individual
burner valves are off before relighting.)
PREHEATING THE CHARBROILER
Allow the charbroiler to preheat for 30 minutes. Rub grates with cooking oil before using.
Note that grease runs forward and drips into the trough in front of the charbroiler before
draining into the grease drawer
COMPONENT PARTS
The charbroiler comes with several standard parts as
illustrated. Each can be easily removed and installed easily
by hand for cleaning and maintenance. Note that the Burner
and Deflector are an assembly and are NOT designed to be
disassembled.
CLEANING
Scrape top grates thoroughly so grease flows to trough and grease drawer uninhibited.
This prevents flare ups. With top grates removed, the trough at the front of the broiler can
be removed for cleaning (use wire brush). Top grates may be immersed in commercial
cleaning compound overnight. In the morning, rinse with hot water to remove any
residues of cleaning compound.
Stainless steel surfaces may be cleaned using damp cloth with mild detergent and water
solution.
Places where fat, grease, or food can accumulate must be cleaned regularly.
Pilot