Filter
Top Products
Fig. 37
Fig. 38
CONTROL VALVES
Inspect the control valve for smooth rotation,
noticeable wear and any possible damage. The
burner flame should increase smoothly as the valve is
opened (highest setting) and decrease smoothly as
the valve is being closed. When inspecting valves,
always apply a light amount of valve grease at the
base of the valve stem. See
LUBRICATION. If valve
grease does improve rotation of the valve, or damage
is found, replace the control valve as outlined under
CONTROL VALVES (36RB/C36RB) or CONTROL
VALVES (36IRB/C36IRB).
RACK SPRING TENSION
ADJUSTMENT
1. Access the springs on the bottom of broiler.
2. Tighten nut to adjust rack spring tension. Adjust
both springs equally so there is approximately
3/4" of thread above the nut. If additional rack
spring tension is required, tighten each nut an
additional 2-3 turns.
3. Check for proper operation.
Fig. 39
SALAMANDER BROILERS RADIANT AND INFRARED - SERVICE PROCEDURES AND ADJUSTMENTS
Page 15 of 17 F45530 (0814)