Filter
Top Products
Fig. 11
5. Remove pilot from bracket.
6. To install replacement pilot:
A. Insert mounting groove on the pilot into the
mounting slot on the pilot bracket.
B. Re-crimp the pilot bracket to secure the
pilot.
C. Slide compression nut and sleeve (ferrule)
over one end of the replacement flexible
tubing for the pilot. Insert flexible tubing into
the pilot and tighten compression nut to
secure.
D. Bend flexible tubing to match original pilot
configuration. Route flexible tubing through
opening in broiler frame and install pilot
bracket to broiler.
NOTE: When installing, ensure the pilot is close to the
ignition ports on the bottom of burner for proper burner
lighting. If necessary, bend the bracket so that the pilot
remains in contact with the burner casting.
E. Slide compression nut and sleeve over the
opposite end of flexible tubing. Insert flexible
tubing into the straight pilot valve on broiler
and tighten compression nut to secure.
7. Check for proper operation.
RADIANT BURNER (36RB/C36RB)
Shut off the gas before servicing the
unit.
1. Adjust rack assembly to the center position.
2. Pull rack assembly out and access the rack stops
on the left and right sides of the rack assembly.
Allow enough clearance at the rear of rack
assembly to rotate the rack stops to a horizontal
position. If the rack assembly is pulled all the way
out the rack assembly will engage the rack stops
and prevent removal.
Fig. 12
3. Grasp the rack assembly near the broiler, rotate
both the rack stops horizontally and pull the rack
assembly out enough for the rack assembly
frame to clear the rack stops.
Fig. 13
4. Grasp the rack assembly and drip tray on each
side to support the tray and remove from broiler.
SALAMANDER BROILERS RADIANT AND INFRARED - REMOVAL AND REPLACEMENT OF PARTS
Page 7 of 17 F45530 (0814)