Vulcan-Hart WSPR2 Range User Manual


 
-
6 -
OPERATION
WARNING: THE STOCKPOT RANGE AND ITS PARTS ARE HOT. BE CAREFUL WHEN
OPERATING, CLEANING OR SERVICING THE STOCKPOT RANGE.
CONTROLS
The burner is in two sections, controlled by two heavy duty infinite control valves. The
center “Star” section (Fig. 2) is on separate burner with an input of 55,000 BTU/hr. It is
controlled by the right burner valve knob. The outer circle of the burner (Fig. 2) is the
other separate 55,000 BTU/hr input burner, controlled by the left burner valve knob.
These two separate burners provide heat flexibility. With one burner off and the second
burner set low, up to both burners full on, you can move from low simmer on up to
110,000 BTU/hr input.
Fig. 1
Fig 2.
LIGHTING INSTRUCTIONS
1. Turn all burner valves to OFF position and wait 5 minutes.
2. Turn gas shutoff valve ON.
3. Light standing pilot with a lit taper. Adjust pilot to ¼” high flame, if necessary, by
turning pilot valve adjusting screw (see Fig. 1) counterclockwise to increase or
clockwise to decrease flame.
4. Turn burner valve to ON position.
5. If pilot does not light, turn main gas supply OFF and repeat steps 1 through 4.
TO COMPLETELY SHUTDOWN THE BURNERS AND PILOT LIGHTS
For complete shutdown: Turn the main gas supply valve OFF.
INNER
BURNER
OUTER
BURNER
PILOT VALVE
SCREW