Filter
Top Products
DISASSEMBLING
Important: Juice extractor should be unplugged from
outlet when disassembling.
• After removing your new juice extractor from the box,
you may want to familiarize yourself with the parts
by disassembling the unit and washing the top parts
(pusher, cover, clutch, cutter blade, strainer basket,
and juice collector bowl, see Figure 1).
• With juice extractor facing you (spout front), put your
hands on both sides of the cover. Using the side
arms for leverage, push back with your left hand
and pull forward with your right, turning the cover
clockwise. This will disengage the cover from the
spring clips and disengage the lid safety interlock.
• Look into juice extractor and remove clutch by
unscrewing counterclockwise.
• Lift out cutter blade.
• Lift out strainer basket.
• Lift off bowl.
ASSEMBLING
• Place bowl on motor base housing and place the spout
facing front between the two raised projections on the
motor base housing.
• Place strainer basket inside the bowl over the hex
drive. Be certain the strainer basket sits flat.
• Place cutter blade inside strainer basket with teeth up.
• Tighten clutch finger until it is tight or snug.
• If using disposable filter, insert it flat against the holes
around the inside of the strainer basket. Once the juice
extractor is running, centrifugal force will push the filter
into perfect position.
• Place cover on bowl with feed chute at the rear, grip
the sides of the lid firmly and turn counter clockwise to
engage the spring clips and the safety interlock.
• IMPORTANT NOTE: The juice extractor will not operate
until the cover is properly assembled to the unit.
3