Filter
Top Products
WARNING:
Risk of personal
injury
Installation procedures must
be performed by a qualified
technician with full knowledge
of all applicable electrical
codes. Failure can result in
personal injury and property
damage.
CAUTION:
Electrical Shock
Hazard
The broiler must be
electrically grounded.
Connect the terminal marked
“GND” or “ ” to a suitable
building ground.
IMPORTANT: Contact a
licensed electrician to install
and connect electrical power
the broiler.
Electrical installation must be
performed by a licensed
electrician in compliance with
all local ordinances and code
requirements.
IMPORTANT: Damage due
to being connected to the
wrong voltage or phase is
NOT covered by warranty.
INSTALLATION (continued)
6
ELECTRCAL HOOK-UP
Refer to the nameplate. Verify the electrical service power. Voltage
and phase must match the nameplate specifications. Connecting the
griddle to the wrong voltage can severely damage the unit or cause
noticeable decreased performance.
Use copper wire suitable for a minimum of 90°C for electrical supply
connections.
Broilers are factory wired three-phase (3ø). For single-phase (1ø)
wiring, refer to the wiring diagram attached to the broiler. Conversion to
1ø must be performed by a licensed electrician.
This broiler is not fused. Protect the circuit with properly sized fuses or
circuit breaker.
An electrical disconnect must be installed readily accessible to the
operator of the broiler.
162 303673 OpManual for Built-In Electric Charbroilers