Filter
Top Products
5
INSTALLATION (continued)
WARNING: Electric Shock hazard
All servicing requiring access to non-insulated electrical components must be
performed by a factory authorized technician.
DO NOT open any access panel which requires the use of tools. Failure to follow this
warning can result in severe electrical shock.
CAUTION:
Risk of
Damage
DO NOT connect or energize
this appliance until all
installation instructions are
read and followed. Damage
to the appliance will result if
these instructions are not
followed.
CAUTION:
Electrical Shock
Hazard
The ground pin of the power
cord plug is part of a system
designed to protect you from
electric shock in the event of
equipment damage.
DO NOT cut the ground pin
from the power cord plug in
order to fit an existing
receptacle;
DO NOT twist a blade of the
power cord plug in order to fit
an existing receptacle.
Contact a licensed electrician
to install an appropriate
electrical circuit and
receptacle.
IMPORTANT:
Damage due to being
connected to the wrong
voltage or phase is NOT
covered by warranty.
F-49RT RETHERMALIZER ELECTRICAL INSTALLATION
This unit is equipped with a cord and NEMA 6-30P plug, and requires a
properly installed NEMA 6-30R receptacle. Contact a licensed elec-
trician to install an appropriate 208 VAC or 240 VAC 30 amp electric
circuit and grounded receptacle.
Be sure the TEMPERATURE CONTROL KNOB is turned to the OFF
position, then plug the POWER CORD into a matching receptacle.
Fig. 3 F-49RT Power Plug and Receptacle Configuration