Filter
Top Products
FILTER INSTALLATION
Remove the protective plastic bag from charcoal filter before installing.
Note air flow direction arrow on each filter, and verify that arrow points
toward plenum when filter is properly installed.
Install filters by inserting top of each into top filter support inside hood
assembly. Pivot bottom of each filter toward rear of hood assembly
and drop it into its respective bottom filter support. Seat each filter
firmly into the bottom filter support.
Install CHARCOAL FILTER first, followed by HEPA AIR FILTER.
Install GREASE BAFFLE last.
GREASE CUP & DRIP PAN INSTALLATION
Install GREASE CUP into brackets below grease baffle.
Note: Failure to install GREASE CUP will allow grease and moisture
from GREASE BAFFLE to drop into FRYPOT, creating both a
SAFETY HAZARD (hot oil splatter) and a HEALTH HAZARD
(contamination of the cooking oil).
Install DRIP PAN into mounting bracket behind fryer door at lower right
front of fryer.
Note: Failure to install DRIP PAN will allow grease, moisture and
other liquids that accumulate on the fryer top panel to drip onto floor,
creating both a SAFETY HAZARD (slip and fall hazard) and a HEALTH
HAZARD (substance capable of supporting bacteria).
NOTE:
The GREASE BAFFLE and
HEPA AIR FILTER actuate
magnetic reed switches when
they are in their proper
positions. They must be
properly installed or the fryer
heater elements will not be
energized.
NOTE:
Remove the protective plastic
bag from the optional
charcoal filter before
installing.
Installing the filter without
removing the plastic bag will
block the air flow. This will
cause the ventilator to shut
down 10 seconds after
start-up, and the fryer will not
heat.
WARNING
SLIP AND FALL
HAZARD
DO NOT operate fryer unless
drip pan is installed. Oil will
drip onto floor creating a
slipping hazard.
CAUTION
BURN HAZARD
DO NOT operate fryer unless
grease cup is installed.
Moisture dripping into hot oil
will cause hot oil to splatter.
INSTALLATION (continued)
10
WARNING LIGHT PANEL
INSERT CHARCOAL FILTER FIRST.
REMEMBER TO REMOVE PLASTIC BAG
PRIOR TO INSTALLING
(NOTE: HANDLES TOWARD FRONT OPENING)
INSTALL FILTER SECOND (NOTE AIR FLOW
ARROW POINTS TOWARD FAN)
HEPA “ ”
INSTALL GREASE BAFFLE LAST NOTE: HANDLES
TOWARD FRONT OPENING
FILTER POSITION SENSORS
GREASE CUP POSITION
AIR
FLOW
FAN
M381 301603 OpM (Supplemental) NFPA Hood