West Bend 7000CF Juicer User Manual


 
12
CLEANING YOUR JUICE EXTRACTOR
Use caution when cleaning the filter bowl with the juicer blade assembled. Wipe
exterior with a damp cloth, and only rinse the interior. Disassemble and clean
following the instructions below.
1. Switch motor base to “0” (OFF) and unplug from the electrical outlet.
2. Disassemble the juicer. Note: The filter bowl may have liquid remaining in the
bottom. With the juicer outlet spout in the closed position, carefully remove the
filter bowl and juicer blade. Empty liquid contents and juicer blade into the sink.
CAUTION: There are many small, sharp blades on the juicer blade. To reduce
the risk of injury, use extreme care when removing and handling the juicer
blade.
3. Wash all loose parts, except the motor base in warm, soapy water, rinse
thoroughly and dry. All parts except the motor base can be washed in the top
rack of the dishwasher. The motor base can be wiped clean with a damp cloth.
CAUTION: Never put the motor base in water or other liquid as damage will
occur.
4. Pay particular attention to properly cleaning the juicer blade which is constructed
of a very fine, filter mesh that must be clean and open for proper operation and
juicing extraction. If necessary, clean the inside of the juicer blade with a nylon
brush. Do not use a metal brush. Hold the juicer blade up to the light to ensure
the mesh is clean and open. CAUTION: To reduce the risk of injury, do not use
the appliance if the juicer blade exhibits excessive wear or damage. Inspect the
juicer blade after each cleaning.
Note: Some fruits and vegetables can stain the plastic parts. To reduce the chance
of staining, rinse and clean all parts immediately after juicing. If staining occurs,
soak parts in water containing 10% lemon juice. Never soak the parts in bleach or
other harsh chemicals.
CLEANING YOUR BLENDER ATTACHMENT (if included)
1. Switch the motor base to “0” (OFF) and unplug from the electrical outlet.
2. Wipe the motor base, powers, and cord with a damp cloth or sponge. To remove
stubborn spots, use a mild, non-abrasive cleanser.
3. To clean the blending jar, disassemble all parts. Carefully wash all parts except
the motor base in warm, soapy water, rinse and dry thoroughly. All parts
except the motor base can be washed in the top rack of the dishwasher.
4. Store the blending jar with the lid off to prevent odor.