Filter
Top Products
15
FREEZER FEATURES
Your model may have some or all of these features. Features that
can be purchased separately as product accessories are labeled
with the word “Accessory.” Not all accessories will fit all models.
If you are interested in purchasing one of the accessories, please
call the toll-free number on the cover or in the "Assistance or
Service" section.
Freezer Shelf
(on some models)
To remove the shelf:
1.
Lift entire shelf slightly.
2.
Move shelf all the way to one side.
3.
Tilt other side up and out of shelf supports.
4.
Pull shelf up and out
To replace the shelf:
1.
Tilt the shelf and insert into freezer compartment.
2.
Insert one end of the shelf all the way into the center of the
shelf supports.
3.
Lower other end of shelf and insert into the shelf supports.
4.
Lower shelf into place.
NOTE:
The shelf should lower slightly and lock into place. If the
shelf does not appear stable, make sure both ends of the shelf
are inserted into the shelf supports.
Frozen food storage guide
Storage times will vary according to the quality and type of food,
the type of packaging or wrap used (should be airtight and
moisture-proof), and the storage temperature. Seal the package
or container securely to prevent taste and odor transfer
throughout the product. Ice crystals inside a sealed package are
normal. This simply means that moisture in the food and air
inside the package have condensed, creating ice crystals.
Put no more unfrozen food into the freezer than will freeze within
24 hours (no more than 2-3 lbs. of food per cubic foot [907-1,350
g per L] of freezer space). Leave enough space in the freezer for
air to circulate around packages. Be careful to leave enough
room for the door to close tightly.
NOTE:
For more information on preparing food for freezing,
check a freezer guide or reliable cookbook.
Adjustable Half-width
Freezer Shelf
(on some models)
To remove and replace the shelf:
1.
Remove the shelf by lifting the shelf up and pulling
straight out.
2.
Replace the shelf over the supports and lower it into place.
Pull-out Freezer Floor
(on some models)
To remove and replace the freezer floor:
1.
Lift both back “fences” up and out.
2.
Remove the freezer floor by pulling it out about 1 in.
(25.40 mm) with one hand around the air tower section
(center back) and one hand at center front.
3.
Lift up floor at rear until hooks release from cabinet and pull
the floor out the rest of the way.
4.
Replace the freezer floor by sliding the floor straight in until
the hooks drop into place at rear of cabinet.
5.
Replace “fences” by aligning pins with socket in the floor, and
pushing down until they snap into place.