Filter
Top Products
INSTALLATION INSTRUCTIONS
1.
2.
3.
4.
5.
BEFORE YOU BEGIN, READ THE FOLLOWING INSTRUCTIONS COMPLETELY AND
CAREFULLY. THEY WILL SIMPLIFY THE INSTALLATION.
After removing the shipping carton, be sure to remove all
6.
Lay two carton corner posts or other protective material
protective packaging materials such as tape and shipping (such as a throw rug) on the floor; then lay the unit on either
pads. Waxy residue from protective shipping material of its sides on the corner posts. The corner posts will
may be removed from compactor with a mild solution of
protect the finish of the compactor and the floor. See
liquid household cleaner and water.
Figure 7. NOTE: Do not truck or handle by console.
Your compactor is designed for recessed installation. A
six (6) inch (15cm) clearance from the right edge of the
drawer front is desirable for added convenience in bag
removal. Also allow twenty-three (23) inches (58.4 cm) in
front of the appliance for drawer removalSee Figure 2.
COMPACTOR
I
WALL OR
OTHER
OBJECTS
(5fJYcmj ’ ’ 6”
(15cml
FIGURE 2 ’
The compactor’s overall dimensions are: Height 33-7/8”
(86cm) (min.), Depth 24” (slcm), Width 15” (38.lcm).
Select a cabinet opening to fit. See Figure 3.
T-
33-l/8”
(Mcm)
I
5
-1. f
Remove drawer as shown:
a. Grip handle and raise front of drawer until it clears
stops. See Figure 4.
b. Grasp side ridges of the drawer and lift drawer out.
See Figure 5.
FIGURE 4
FIGURE 5
Remove any materials that are shipped in the drawer.
Some models have a literature storage compartment
located inside the front panel. See Figure 6. DO NOT
REMOVE THE BAG.
7.
8.
9.
FIGURE 7
Remove the cardboard shipping pad located on the bottom.
See Figure 7. Stand compactor upright.
A grounded receptacle should be located 18” (45.7 cm)
(min.) from the floor and in the center of the opening. See
Figure 8.
7l-lT
?
18” (45.7 cm) MIN.
IF-V
FIGURE 8
Before moving the compactor into position, measure the
cabinet opening as shown in Figure 9. To determine if
height adjustment is required, see steps 9 and 10 below.
-CABINET OPENING
FIGURE 9
The rear wheels of your compactor are preset for a
minimum cabinet opening of 34” (86.4 cm) (position A). To
adjust for higher openings, tilt the compactor to one side
and support with a corner post or a screwdriver handle.
CAUTION: Use care so that the compactor does not
drop on your hand.
10.
To adjust the height, remove screw from position “A” in
Figure 70. Move the rear wheel and screw to position “B
or C”:
33-718” to 34-3/l 6” (86 cm to 86.8cm) use position “B”:
34-3/16” to 34-l/2” (86.8cm to 87.6cm) use
position “C”.
A
3Y
t:
FIGURE 10
Repeat for other rear wheel.
2
4152821