Filter
Top Products
11.
Loosen the screws in the top retaining brackets. Rotate
the brackets from shipping postion to the install position.
Retighten. See Figure 11.
/ ’
RETAINING
EIRACKmS
FIGURE 11
NOTE: Position ‘A” - Compactor frame will be flush with
cabinets. Remove cabinet mount screws from retaining brack-
ets. Save for use in step 73.
Position “B” - Midpoint between positions ‘A” and ‘C. ”
Position “C” - Drawer front will be flush with cabinets.
12.
When moving or lifting the compactor, use a glove to
protect and cushion your hand.
To prevent damage to floor covering, do not allow the rear
frame of the compactor to touch the floor when lifting or
rolling. See Figure 12.
FIGURE 12
Align the rear of the compactor with the cabinet opening.
Plug the power cord into a properly grounded receptacle.
See Figures 7 and 8.
Lift the front of the compactor and roll into the opening
until the retaining brackets stop the unit.
13.
Fasten the retaining brackets to the underside of the
counter top with the screws provided. Use auxiliary clip for
fastening to cabinet front when counter top mounting
method is not permissible. See Figure 13.
RETAINER BRACKET
RETAINER BRACKfl
MOUNTING SCREW
COUNTER TOP MOUNTING
AL TERNATE CABINET FRONT
MOUNTING
FIGURE 13
Lift the front of the compactor until it is parallel with the
cabinet front. Place a screwdriver or other wedge under
the front edge of the compactor.
14.
Loosen the screws to the front levelers (do not remove
screws). Pivot the levelers to the floor and retighten
screws. See Figure 14.
FIGURE 14
15. Replace the drawer.
16.
The Use and Care Guide provides complete details for
operation and care of your compactor.
ADJUSTABLE TOE PLATE
In some installations, the toe plate may rub the floor covering.
If this occurs, the toe plate clearance may be changed as
follows:
1.
Determine the amount of interference of the toe plate with
the floor covering.
2. Remove the drawer from the unit. (Refer to Step 4 of the
Installation Instructions.)
3. ;;;;;;,the floor. Lay drawer so the front panel faces
4. With a ruler and a pencil or chalk, draw a line where the toe
plate interferes with the floor covering.
5. Use a pair of scissors and cut toe plate along this line. See
Figure 15.
6.
Replace drawer in unit.
CHANGING FRONT PANEL COLOUR
During installation, or in the future, you may wish to change the
front panel colour. Your compactor has one reversible front
panel which offers two colour options.
See details of panel assembly in Figure 16.
3
FIGURE 16
4152821