Whirlpool 8ED22DQ Refrigerator User Manual


 
PART
Defrost pan
WHAT TO USE
Sponge or cloth with
mild detergent and
warm water
HOW TO CLEAN
. Remove base grille. (See page 16.)
. To remove defrost pan, lift pan over wire brace
(remove tape; if any).
. Wash, rinse and dry thoroughly.
l
Replace with notched corner to the rear. Push it in
all the way.
l
Make sure defrost pan drain tube is pointing into
pan.
l
Replace base grille.
Condenser coils
Vacuum cleaner with
. Remove base grille.
extended narrow
l
Vacuum coils when dusty or dirty. Coils may need
attachment
to be cleaned as often as every other month.
l
Replace base grille.
Floor under
refrigerator
Floor cleaners
l
Roll refrigerator out only as far as the water supply
line allows.
l
Clean floor.
l
Roll refrigerator back into place.
l
Check to see if the refrigerator is level.
Vacation and moving care
Long vacations
Remove all the food if you are going for a month
or more. Turn off the water supply to the ice
maker at least one day ahead. When the last
load of ice drops, turn off the ice maker. Make
sure all ice crescents are dispensed out of the
mechanism.
Unplug the refrigerator. Clean, rinse it well and
dry. Tape rubber or wood blocks to the tops of
both doors to prop them open far enough for air
to get in. This will keep odor and mold from
building up.
Personal Injury Hazard
Do not allow children to climb on, play near
or climb inside the refrigerator when the
doors are blocked open.
They may become injured or trapped.
To restart refrigerator, see “Using Your Refrigera-
tor” on page 7.
Short vacations
No need to shut off the refrigerator if you will be
away for less than four weeks. Use up perish-
ables; freeze other items.
1. Turn off your ice maker by raising signal arm.
2. Shut off the water supply to the ice maker.
3. Empty the ice bin.
Moving
Shut off the ice maker water supply a day ahead
of time. Disconnect the water line. After the last
supply of ice drops, lift the signal arm to turn off
the ice maker.
Remove all food. Pack frozen food in dry ice.
Unplug the refrigerator and clean it thoroughly.
Take out all removable parts. Wrap all parts
well and tape them together so they don’t shift
and rattle. Screw in the leveling legs; tape the
doors shut; and tape the electric cord to the
cabinet.
When you get to your new home, put every-
thing back and refer to page 5. Also, remember
to reconnect the water supply line.
19