Filter
Top Products
Adding an item during a cycle
You can add an additional item to the
dishwasher anytime before the Cycle
Control knob reaches Light Wash. Items
added after the Cycle Control knob reaches
Light Wash may only be rinsed.
1. Lift up the door latch to stop the cycle.
Wait for spraying action to stop before
opening the door.
2. Open the door and add the item.
Using delay wash
You can set the dishwasher to start a cycle
from 2 to 4 hours later.
1. Press the desired Cycle pad.
2. Press the desired Option pads.
3. Turn the Cycle Control knob clockwise to
the number of hours (from 2 to 4 hours)
you want the dishwasher to delay before
the selected cycle starts.
4. Close and latch the door.
NOTES:
• You can add items while time is counting
down. Close and latch the door. The
Cycle Control knob will not advance if the
door is unlatched.
• Rinse Only and Light Wash cycles cannot
be delayed.
15
SETTING THE CONTROLS
Punched Hole
52.50/52.0 Dia.
DU400
DELAY HOURS
2
4
3. Close the door, but do not latch it. Wait
30 seconds for the air in the dishwasher
to warm up. Doing so reduces the
amount of moisture in the vent when
restarting a cycle.
4. Close the door firmly until it latches. The
dishwasher resumes the cycle.
8051220 v15 (c41) 7/1/98 9:09 AM Page 15