Filter
Top Products
13
Meat Thermometer
On models without a temperature probe, always rely on a meat
thermometer to determine doneness of meat and poultry. The
internal temperature, not appearance, is what counts. A meat
thermometer is not supplied with this appliance.
■
Insert the thermometer into the center of the thickest portion
of the meat or inner thigh or breast of poultry. The tip of the
thermometer should not touch fat, bone or gristle.
■
After reading the thermometer once, push it into the meat
¹⁄₂
in. (1.25 cm) more and read again. If the temperature
drops, cook the meat or poultry longer.
■
Check all meat in two or three places.
Oven Vents
The oven vent releases hot air and moisture from the oven, and
should not be blocked or covered. Doing so will cause poor air
circulation, affecting cooking and cleaning results. Never set
plastics, paper or other items that could melt or burn near the
oven vent.
On coil element models, the element can be used when the oven
is in use as long as the cookware does not extend more than 1 in.
(2.5 cm) over the element.
Baking and Roasting
ACCUBAKE
®
DUO SYSTEM
®
Temperature Management
(on some models)
The ACCUBAKE DUO SYSTEM technology electronically
regulates the oven heat levels during preheat and bake to
maintain the most uniform temperature control.
Two temperature sensors will independently control the bake and
broil elements for optimal cooking results. The bake and broil
elements cycle on and off in intervals. The bake element will glow
red when cycling on, the broil element will not. This feature is
automatically activated when the oven is in use.
Before baking and roasting,
position racks according to the
“Positioning Racks and Bakeware” section. When roasting, it is
not necessary to wait for the oven preheat conditioning time to
end before putting food in unless recommended in the recipe.
To Bake or Roast:
1.
Press BAKE.
2.
Press TEMP or TEMP/TIME “up” or “down” arrow pad to set
a temperature other than 350°F (175°C) in 5 degree amounts.
The bake range can be set between 170°F and 500°F (75°C
and 260°C).
When the oven temperature is greater than 170°F (77°C), no
preheat conditioning time will be shown in the display. The
preheat conditioning time will not change if the temperature is
reset before the countdown time ends.
3.
Press START. The temperature can be changed after this
step. START does not need to be pressed again.
If baking and roasting while the minute timer is counting
down, the set temperature can be seen for 5 seconds by
pressing BAKE.
4.
Press CANCEL or OFF when finished.
Preheating
After START is pressed, the oven will enter a timed preheat
conditioning. “PrE” (on some models) and the countdown time
will appear on the display. When the preheat conditioning time
ends, a tone will sound and the selected temperature will appear
on the display.
Preheat temperatures are affected by varying factors such as
room temperature and peak energy usage times. It is normal for
the temperature showing on the display and the actual oven
temperature to differ due to the cycling of the elements.
Waiting an additional 10 minutes, after the preheat conditioning
time ends, to put food in the oven is suggested when baking
foods with leavening ingredients, such as yeast, baking powder,
baking soda and eggs.
Choice Bake
®
Function
(on some models)
The CHOICE BAKE
®
function eliminates the top heat during oven
cooking. It is ideal for baking pies, casseroles and breads, and for
roasting foods that require longer and slower cook times such as
poultry and roasts.
Similar to the baking and roasting function, the bake elements or
burners cycle on and off at intervals during CHOICE BAKE
®
cycle. However, the cycle duration for the broil element is much
shorter during CHOICE BAKE
®
, allowing less top browning of
foods and more customized control for your baking results.
Stainless steel
■
Light, golden
crusts
■
Uneven
browning
■
May need to increase baking time.
Stoneware
■
Crisp crusts
■
Follow manufacturer’s instructions.
Ovenproof
glassware, ceramic
glass or ceramic
■
Brown, crisp
crusts
■
May need to reduce baking temperatures
25°F (15°C).
1. Coil Element Models
2. Ceramic Glass Models
BAKEWARE/
RESULTS
RECOMMENDATIONS
1
2