Whirlpool 9761040 Range User Manual


 
8
ELECTRONIC OVEN CONTROLS
Style 1 - Electronic Oven Controls (on some models)
Style 2 - Electronic Oven Controls (on some models)
Display
When power is first supplied to the appliance, PF or a flashing
time will appear on the display. Press CANCEL or OFF/CANCEL
to clear PF or flashing time from the display.
If PF or flashing time appears, a power failure has occurred.
Press CANCEL or OFF/CANCEL and reset the clock if needed.
When the oven is not in use, the display shows the time of day.
When performing a timed cook function, the display will show
either hours and minutes, or minutes and seconds.
Start
The START or START/ENTER pad begins any oven function. If not
pressed within 5 seconds after pressing a function pad, the
START? indicator light will flash as a reminder. On some
models, START? will appear on the display.
If not pressed within 5 minutes after pressing a function pad, the
oven display will return to the time of day mode and the
programmed function will be canceled.
Cancel or Off/Cancel
The CANCEL or OFF/CANCEL pad stops any function except the
Clock, Timer and Control Lock.
Clock
On some models, this is a 12-hour clock that shows a.m. and
p.m.
To Set:
Before setting, make sure the oven and Timer are off.
1. Press CLOCK.
2. Depending on your model, press the HR or MIN or TEMP/
TIME up or down arrow pads to set the time of day,
including a.m. or p.m.
3. Press CLOCK or START.
Tones
Tones are audible signals, indicating the following:
One tone
Valid pad press
Oven is preheated (long tone)
Function has been entered
Reminder, repeating each minute after the end-of-cycle tones
Three tones
Invalid pad press
Four tones
End of cycle
Reminder Tones: Reminder tones may be turned off. On some
models, press and hold STOP TIME for 5 seconds. rEP OFF or
off will appear in the display. Repeat to turn reminder tones
back on, and rEP on or on will appear in the display.
All Tones: All of the above tones are preset on, all except the
end-of-cycle tones can be turned off.
To Turn Off/On (on some models): Press and hold START TIME
for 5 seconds. A tone will sound, and Snd OFF will appear on
the display. Repeat to turn tones on, and Snd on will appear on
the display.
On some models, only the loudness of the tones can be adjusted.
On other models, the tones cannot be adjusted or turned off.
A.Display
B.Timer
C.Clock
D.Auto clean
E.Oven light pad
(on some models)
F. Sequence programming
(on some models)
G.Oven settings
H.Warming drawer
(on some models)
I.Temperature
J.Timed cooking
(on some models)
K.Hour/minute
(on some models)
L.Start/control lock
M.Cancel
A.Oven display
B.Clock
C.Timer/cancel
D.Start/enter (control lock)
E.Auto clean
F. O ff/ ca nc el
G.Temperature/time
H.Cook time
I.Start time
J.Custom broil
K.Bake
A
B
C
D
E
F
G
H
I
J
K
LM
ABCDEF
KJ
IH
G