Whirlpool ADG 7470 Dishwasher User Manual


 
GB
-1-
Chart
PROGRAMME SELECTION BUTTON
Press button “P” (repeatedly) until the indicator of the required programme lights up (see “Table of
programmes” below).
ON
BUTTON
OFF
BUTTON
START BUTTON
The indicator lights up during operation, flashes when a fault occurs and goes off at the end of the programme.
START BUTTON RESET FUNCTION
Press this button for at least 2 seconds; the selected programme and options are cancelled. Main failure
displays (repeated flashing of the START indicator lamp) can be cancelled by RESETTING. Detailed
instructions are given in chapter “What to do if...”.
1) Programme data obtained in conformity with European standard EN 50242, obtained under normal conditions
(without additional options) and may vary depending on conditions. Differences of up to 20 minutes are possible
with sensor programmes as a result of the appliance’s automatic calibration system.
2) Reference programme for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: fo
r
detailed information on the EN/Standard loading comparison test and other tests, contact the following address:
“nk_customer@whirlpool.com”.
Table of programmes
Deter-
gent
Consumption
P
Programmes Loading instructions
Litres kWh
Minutes
1)
1
Pre-Wash cold
Crockery to be washed later. 5.0 0.02 10
2
Quickwash 40°C
Lightly soiled crockery, with no
dried-on food.
* Use of tablets
not recommended.
X
*
13.0 0.70 30
3
Eco
2)
50°C
Normally soiled crockery.
Energy-saving programme.
X 15.0 1.05 165
4
Intensive 70°C
Recommended programme for
heavily soiled crockery, especially
suitable for pots and pans.
X 17.0 1.65 145
5019 396 01787ADG 7470
BEFORE USING THE APPLIANCE FOR THE
FIRST TIME CAREFULLY READ THIS QUICK
REFERENCE GUIDE AND THE ASSEMBLY
INSTRUCTIONS! THE GUARANTEE IS NOT
APPLICABLE IF FAULTS ARE CAUSED BY
INCORRECT USE OF THE APPLIANCE.
Quick reference guide