Whirlpool ADG 7470 Dishwasher User Manual


 
GB
-5-
Switch off the appliance Everything o.k. ...
Wash cycle
Select programme
Quick, permanent or alternating
6
7
8
Exercise caution when opening the door: beware of hot steam.
Only press the OFF button once the START indicator lamp has switched off.
All the indicator lamps switch off. Unload the appliance, starting from the lower rack in order to avoid any residual drips of water falling onto crockery below.
Maintenance and care
Maintenance and care
Change the programme in progress:
Press the START button (for 2 seconds) until the START indicator lamp
switches off.
Close the door.
(Water drains for up to 60 seconds).
Open the door.
Select a new programme.
Press the START button.
Overview of programmes
The max. possible number of programmes is illustrated in the chapter “Chart”. The corresponding programmes for your appliance can be found on the panel (page 1).
Choose programme according to the attached table of programmes (page 1).
Duration of the programme depends on the external conditions in the apartment, temperature and pressure etc.
The dishwasher door must be closed and the water tap open.
To load crockery, open the door with caution:
Close the door again.
The programme resumes the cycle from where it was interrupted.
Beware of hot steam!
The wash cycle can be interrupted at any time by pressing START (see chapter “What to do if...”).
Rectifying minor faults yourself ...
10
9
Filters
Check and
clean if
necessary
Unscrew filter
cylinder, remove it
and fine sieve...
Rinse under running
water ...
Screw on filter cylinder NOTE MARK!
Unscrew
and remove
upper arm ...
Spray arms
Remove
blockages/
deposits.
Insert
Clean spray
nozzles under
running water
(use toothpicks if
necessary) ...
Insert and screw on lower and upper arms tightly.
Unscrew
and remove
lower arm ...