Whirlpool ADG 7470 Dishwasher User Manual


 
GB
-3-
Daily check
E
L
S
S
E
L
E
L
S
E
L
S
1
2
3
Adding rinse aid
(not necessary when you use tablets). How to adjust the rinse aid dosage regulator
Daily use
The salt level indicator lamp may remain lit for the duration of several wash cycles. If the
water hardness level falls within category (soft),
no
salt is required.
Salt indicator
(depending on
the model)
The indicator lamp on the control panel lights
up when SALT NEEDS TO BE ADDED.
orange: OK. clear: NEEDS TO BE ADDED
Rinse aid indicator (depending on model)
The indicator lamp on the control panel lights up when RINSE AID NEEDS TO BE
ADDED.
dark: OK. clear: NEEDS TO BE ADDED
Only use rinse aids recommended for use in domestic dishwashers.
Immediately
wipe away any rinse aid spilt accidentally. This prevents the formation of excess suds which can cause a fault function of the appliance.
If there are streaks: reduce the dosage by turning the dial to a lower setting (1-3). If crockery is not perfectly dry: increase the dosage by turning the dial to a higher setting (5-6). Plastic dishes have more difficulty drying and a higher rinse aid
setting will not improve the situation.
Detergents with rinse aid incorporated may be effective only with longer programmes. In the case of shorter programmes, detergent residue may be a problem (if necessary, use powder detergent). Detergents with rinse aid incorporated tend
to form excess suds.
Visual indicator
(depending
on model).
Unscrew cap.
Fill the salt
reservoir with
water before the
first wash only.
Add salt
(never add
detergent!).
min. 1.5 kg
max. 2 kg
Visual indicator (depending
on model). Screw on the cap.
Salt residues around cap
need to be removed.
If required,
open the cover
B (press right
button).
Open the cover A
(press left button).
Only fill the
detergent dispenser
prior to starting a
wash programme.
By pressing
dedicated ribs
shut the cover.
Tablet / gel / powder
Add rinse aid
to the max.
line ~150 ml
The rinse aid dosage can be adjusted to the
detergent used. The lower the setting,
the less rinse aid is dispensed
(factory setting: position 4).
Press the button to open the cover B. Using a
coin or similar object, turn the arrow to the
desired setting. After adjusting the rinse aid
setting, shut the cover again.
Visual
indicator
Adding detergent -
Use only detergent specifically for dishwashers in accordance with the supplier’s recommendations
Use only one tablet per one
cycle, only placed in detergent
dispenser.
All types of tablets can be
used, but for 2 in 1 type
adding of salt is mandatory.
Filling the salt reservoir -
Dissolve limescale (not necessary if water hardness level is set to “soft”!)