Filter
Top Products
CHANGING THE BIN DOOR PANEL
You can easily change the color of the front panel
on the storage bin door. Four colors are available;
Blark, Almond, Harvest Gold and White.
To change the panel :
_~ -~-.___
4. Choose the color you want to show and carefully
slide the panels back into the door, being careful
not to scratch the panel as it’s inserted.
5. Replace the handle and screws.
1. Ooen the bin door. Remove the two screws on
top cjf the door, which hold the handle.
2. Remove the handle
Note: A brushed chrome door panel is available
that you can order from your dealer as part No.
755340.
3; C~reiully slide the panels out. You will find two
pane Is with four colors.
You can also have a decorative wood front to
match existing cabinets. The panel should be l/4”
(6 mm) thick and 17” x 13-3/16” (433 mm x
335 mm). Remove the metal panels and break off
the ribs on the door insulation to allow for wood
thickness.
FILTERING AND TREATING WATER
In n‘ost areas it will be beneficial to filter or treat
th; \tvater being supplied to the ice machine. It can
Improve the reliability of the machine, reduce
vvatrr system maintenance and produce the best
quaicti/ of ice.
The installation of a polyphosphate feeder will
generally reduce scale build-up and the ice machine
Lvirl -equire less frequent cleaning.
Municipal water systems are generally treated with
chlorine to maintain a safe potable water supply.
Activated carbon filters will sufficiently remove
the residual chlorine from the water to reduce
surface staining of stainless steel materials in the
ice machine.
For information on filtering and treating the water,
see the dealer from whom you purchased your ice
maker or your WHIRLPOOL Franchised TECH-
CARE@ service company.
TO SHUT DOWN THE ICE MAKER
1. imi;rn ice maker to “OFF.”
2. Remove all ice frorr storage bin.
3. Shut off the water supply.
4. Remove front grille (Figure 2).
5. [),sconnect the inlet and outlet lines to water
vain. Allow these lines to drain and then recon-
nect to the valve,
6. Replace front grille .jnd screws.
7. Remove water from drain lines and drain water
pan if the unit will be subjected to freezing tem-
peratures during shut down.
8. Before using again, clean and sanitize the ice
maker and storage bin.
Oiling:
All components of the ice maker are permanently
lubricated at the factory. They should not require
any additional oiling throughout the normal life of
the machine.