Filter
Top Products
.
POWER CLEAN* Washing System
Your dishwasher cleans by spraying a mixture of hot, clean water and detergent
against soiled surfaces of dishes. When a cycle is started,the dishwasher fills with water
to about the level of the heating element. This water is pumped through the rotating
spray armsthrough the POWER CLEAN Module which removes food particle&and back
through the rotating spray arms. Soiled water is pumped out and replaced with clean
water during a cycle - the number of times depends on the cycle being used.
The POWER CLEAN* Module removes food
particles from the water, stores them, then
washes them down the drain.
Load dishes so soiled surfaces face pow-
erful spray from rotating arms.
Step-saving preparation for washing
It is not necessary
to rinse dishes before
putting them into the
dishwasher. Just re-
move large pieces,
bones, and other hard
items. The POWER
CLEAN Module will
remove food parti-
cles from the water. It contains a chopping de-
vice which will reduce the size of food items.
If hard items such as fruit seeds, nuts and
egg shells enter the POWER CLEAN Module,
you might hear chopping, grinding, crunch-
ing or buzzing sounds. Those sounds are nor-
mal when hard items enter the module. DO
NOT LET MmALLIC ITEMS GET INTO THE POWER
CLEAN MODULE.
Water must be hot
For best cleaning and drying resutts, water should be at least
140°F (60°C).
1. Turn on hot water faucet nearest the dishwasher. Let water run
until it is as hot as possible.
2. Hold a candy or meat thermometer in the stream of hot water
to measure the temperature.
3. If the temperature is too low, have a qualified person raise
the water heater thermostat setting.
*Tmk.