Filter
Top Products
The CLEAN Signal Light
The RESET OPTIONS Button
The CLEAN Signal Light will come on when a
If you want to change a selected
Option.
washing cycle is complete.
push the RESET OPTIONS Button. Reselect an
To turn it off. Turn the Control Knob clockwise
option, if desired.
slightly until the light goes off
Energy saving tips
You can help save energy if you:
1. Wash full loads. Running a half-ftlled dish-
washer uses the same amount of electricity
and hot water as a fully loaded machine.
3. Alr dry dlrher when you don’t need a rapid
drylng cycle Allow longer dryrng times
(overnlght).
2. Use the LOW ENERGY WASH Cycle whenever
possible. It uses less hot water and energy
than otherwash cycles.
4.
5,
6,
7.
load correctly for best washing results. In-
correct loading may cause poor washing
and the need to rewash all or part of the
load.
Don’t pre-rlnse normally soiled dishes. Se-
lect the correct cycle for the load and use
the recommended amount of detergent for
good washing results without hand rinsing.
Use Your dlshwasher during off-peak hours.
Local utilities recommend this to avoid
heavy usage of energy at certain times of
day.
Kitchen cleanup can be done quickly and
efficiently through the use of your dishwasher.
Most appliance parts that can fit in the dish-
washer can be
cleaned
by it. Burned-on soil,
however, should be cleaned by hand.