Filter
Top Products
Before starting your dishwasher
1. Spin the Upper Spray Arm to make sure
nothing will stop it from turning freely
2. Push door firmly when closing and it will
automatically latch.
3. Run hot water at sink nearest dishwasher
until it is hot. Turn it off.
Starting your dishwasher
CLEAN SELECTOR BUTTONS OPTION SELECTOR BUTTONS
POTS & PANS cycle...
1. Push POTS & PANS Clean Selector Button.
2. Push button for option desired.
3. Turn Cycle Control Knob clockwise to
dot marked POTS & PANS.
- POTS & PANS and HEAVY WASH Cycles
share the same spot on the dial. The
Clean Selector Button determines
which cycle operates.
The dlshwasher will automatlcally start
that cycle.
NORMAL WASH cycle...
1.
2.
3.
Push NORMAL WASH Clean Selector
Button.
Push button for optlon destred.
Turn Cycle Control Knob clockwise to
dot marked NORMAL WASH. The dlsh-
washer will automatlcally start that
cycle.
RINSE 6 HOLD cycle...
1. Push NORMAL WASH Clean
Selector
Button.
2. Select AIR DRY Optlon only.
3. Turn Cycle Control Knob clockwlse to
dot marked RINSE & HOLD. The dlsh-
washer will automatlcally start that
cycle.
HEAVY WASH cycle...
1. Push HEAW WASH Clean Selector Button.
2. Push button for option desired.
3. Turn Cycle Control Knob clockwise to
dot marked HEAVY WASH.
- HEAVY WASH and POTS & PANS Cycles
share the same spot on the dial. The
Clean Selector Button determines
which cycle operates.
The dishwasher will automatically start
that cycle.
LOW ENERGY WASH cycle...
1. Push NORMAL WASH Clean Selector
Button.
2. Push button for option desired.
3. Turn Cycle Control Knob clockwise to
dot marked LOW ENERGY WASH. The dish-
washer will automatically start that
cycle.
Changing a setting
You can change a setting anytlme durlng
any cycle.
1.
Press In the door latch to unlatch the door
and stop the cycle.
2. Turn the Cycle Control Knob clockwlse to the
cycle you want.
3. Be sure the detergent dispensers are fllled
properly for the new cycle.
4. Close and latch the door. The dlshwasher will
automatlcally start the new cycle.
To add a dish after starting
4.
1.
To be sure the added Item Is washed and
rinsed, make sure the Cycle Control Knob
has not passed LOW ENERGY WASH.
2. Unlatch the door to stop the cycle.
2. Open the door and add the dish.
5.
Close the door.
Do not latch
It. Wait 30 sec-
onds tor alr In the dlshwasher to warm up.
This helps reduce the amount of moisture
that can come from the vent when restart-
Ing the cycle.
Latch the door. The dishwasher will start
from where It stopped.