Filter
Top Products
CLEAN signal light
The CANCEL pad allows
you to cancel a cycle, to
clear the signal lights or to
make a new selection. If the
dishwasher is washing, it will
The CLEAN signal light
comes on at the end of a
cycle to show that the load
is clean. It will stay on until
CANCEL or any other con-
go into a 2 minute drain automarlcally DefOre
trol pad is pressed.
shutting off. Pressing CANCEL again stops the
drain. If the dishwasher had not been started or
is not washing, it will clear the display. Pressing
CANCEL again will start a 2 minute drain, if
needed.
Energy saving tips
You can help save energy it you:
1. Wash full loads. Running a half-filled dish-
washer uses the some amount of electricity
and hot water as a fully loaded machine.
2. Air dry dishes when you don’t need a rapid
drying cycle. Allow longer drying times
(overnight].
3. load correctly for best washing results. In-
4. Don’t pre-rinse normally soiled dishes. Se-
correct loading may cause poor washing
lect the correct cycle for the load and use
and the need to rewash all or port of the the recommended amount of detergent for
load.
good washing results without hand rinsing.
6.
Use your dishwasher during off-peak hours.
Local utilities recommend this to avoid
heavy usage of energy at certain times of
day
6. Kitchen cleanup can be done quickly and
efficiently through the use of your dishwasher.
Most appliance parts that can fit in the dish-
washer can be cleaned by it. Burned-on soil,
however, should be cleaned by hand.
10