Filter
Top Products
CONTROL PADS
Starting your dishwasher
Four control pads and the signal lights allow
When dishes are loaded and ready to be
you to set and check the dishwasher’s function. washed...
When first installed, the signal lights will flash
rapidly in order. The signal lights will also flash
following a powerfailure. Press the CANCEL pad
twice to clear the signal lights.To start the dish-
washer, press the START pad once to display the
cycle. The dishwasher is preset for the NORMAL
cycle with the HEAT DRY option. If you want this
cycle, press START again.
1. Read “Important Safety Instructions’on page
2 before starting your dishwasher.
2. Spin the Upper and Lower Spray Arms to
make sure nothing will stop them from turning
freely.
3. Push door firmly when closing and it will auto-
matically latch.
To select a different cycle and/or option, just
press the CYCLE pad and/or OPTIONS pad until
the cycle and/or option you want is indicated
by the signal lights. Each press of the pad
advances the signal light to the next cycle or
option. Press START to begin the cycle you se-
lected. After each use, the dishwasher remem-
bers the cycle and options used. The next time
the display is lit up for selection, it will show the
last cycle that was run.
4. Run hot water at sink nearest dishwasher until
it is hot. Turn it off.
5. Press the START pad. Skip to step 7 if you want
to run the cycle indicated by thesignal lights.
6. You may select a different cycle by pressing
the CYCLE pad. You may select a different
option by pressing the OPTION pad.
7. Press the START pad again.
Selecting a cycle
POTS & PANS
Maximum cleaning for cooked-on
or baked-on foods. The cycle time
delays while the dishwasher auto-
matically heats the water to 145°F
(63°C) in both washes and in the last
rinse (marked *I. Cycle time** is 72
minutes plus the time needed to
heat the water.
WASHING AND
RINSING AND
HEATING WATER
HEATING WATER DRYING CLEAN
,---- p-~-5
8