Filter
Top Products
Using the rinse agent dispenser
Keep the rinse agent dispenser filled with a
liquid rinse agent. A rinse agent greatly
improves dish drying by helping water
flow off them during the last rinse. A rinse
agent also keeps water from forming drop-
lets and drying as spots or streaks.
A small amount of rinse agent automati-
cally releases into the rinse water during the
final rinse of each cycle. For best drying
results, check dispenser periodically to
see if it needs filling.
To check dispenser:
l Check center of Fill Indicator Cap. Clear
means it needs filling.
OR
l Remove Fill Indicator Cap. An “E” is visible
when dispenser is empty.
To fill dispenser:
The rinse agent dispenser holds 6 ounces
(175 mL). Under normal conditions, this
lasts about 3 months.
1. Open dishwasher door completely.
2. Remove Fill Indicator Cap.
3. Add rinse agent. Fill to smallest opening
in lower par-l of dispenser only. Overfilling
may cause rinse agent to leak out. This
will not harm the dishwasher, but could
cause oversudsing.
4. Clean up any spilled rinse agent with a
damp cloth.
5. Replace Fill Indicator Cap. Keep it
closed tightly.
NOTE: You do not have to wait until the
dispenser is empty before refilling, but do
not overfill it. Your dishwasher is designed to
use a liquid rinse agent. You do not need to
use a solid or bar-type rinse agent.
Cap center clear
when
empty
OR
“E” visible
when
empty
Keep dispenser filled for best drying results
11