Filter
Top Products
Changing or cancelling a program
After a program has started, touch CANCEL
Pad once.The dishwasher will automatically go
into a 2 minute drain period, then shut off. Check
detergent dispensers to make sure they are
filled properly for the new program. To restart
the dishwasher, touch SELECT PROGRAM and SE-
LECT OPTION Pads, then touch START.
To cancel a program:
l
Touch CANCEL Pad once. The dishwasher Will
automatically drain for 2 minutes, then shut off.
OR
l
Touch CANCEL Pad twice. The display will
clear and the dishwasher will immediately
shut off.
Electronic display and status indicators
The electronic display shows...
l
“E4 or E2” shows whenever there has been a
control panel malfunction.
Touch CANCEL Pad to clear display. The dish-
washer may drain before shutting off. If the
display will not clear, call your TECH-CARE”
service technician. (See page 15.)
l
The number of minutes remaining in a pro-
gram (60, 59, 58 minutes, etc.). This displayed
time only represents the wash, rinse and HEAT
DRY time. The program time delays while the
water is heating.
l
The number of delay
hours selected
(1,2, . . . . 9).
CLEAN shows on the display
immediately after
Status Indicators let you know what your dish-
washer is doing during a program.
WASH shows on the display during the wash
portion of the program. The indicator goes off
when the last wash is completed.
RINSE shows on the display during the two final
rinses before drying.
l
“PF” shows on the display whenever there has
been a power interruption or failure.
To add a dish after starting
1. To be sure the added item is washed, make
3. Open the door and add the dish.
sure the WASH Indicator is still on. The
display flashes when the door is left ajar.
2. To stop the program, unlatch the door by
pushing in the latch handle under the con-
trol panel. Do not open the door until the
spray arms stop spinning. The display will
flash.
4. Close the door. Do not latch it. Wait 30 set
ondsforairin thedishwashertowarmup.Thi
helps reduce the amount of moisture the
can come from the vent when restarting the
program.
5. Push in on door until it latches. The dish
washer will restart and continue the
program.