Filter
Top Products
DELAY Pad
[ml/u
The DELAY pad allows you to de-
lay the start of the dishwasher
from 1 up to 9 hours. Each touch
of this pad adds another hour of delay to the digi-
tal display After 9 hours, touching the DELAY pad
will change the display back to 1 hour. The DELAY
HOURS indicator will show on the display.
To start the dishwasher during the delay, touch
cancel to cancel the existing program; select de-
sired program. then touch START. The dishwasher
will start immediateiy
CANCEL Pad
q
The CANCEL pad allows you to cancel a
program or to clear the display. If the
dishwasher is washing, it will go into a 2
minute drain automatically before shutting off. If
the dishwasher had not been started, it wili clear
the display.
Changing or cancelling a program
After a program has started, to cancel:
l
Touch CANCEL pad once. The dishwasher will
automatically drain for 2 minutes, then shut off.
OR
l
Touch CANCEL pad twice. Tne display will clear
and the dishwasher will immediately shut off.
To restart the dishwasher
l
Check detergent dispensers to make sure they
are filled properly for the new program.
l
Touch START to run the dishwasher in the Program
Memory.
OR
l
Select desired program and options, then touch
START.
Electronic display and status indicators
The electronic display shows...
Status indicators let you know what your dish-
washer is doing during a program.
l
The number of minutes remaining in a program
(60,59,58 minutes, etc.) represents the WASHING,
RINSING and HEAT DRY times. The program time
remans the same while the water is heating.
l
The number of delay hours selected (1,2,...,9).
The display also points out operating problems:
l
“PF” shows on the display whenever there has
been a power interruption or failure.
0 “E4, E2. El or EO” show whenever there has been a
control panel malfunctron.
Touch CANCEL pad to clear display. The dish-
washer may drain before shutting off. If the dish-
washer display will not clear or continues to
show a code at the end of each cycle, call your
TECH-CARE” service technician. (See page 18.)
WASHING shows on the display during the wash
portion of the program. The indicator goes off
when the last wash is completed.
RINSING shows on the display during the two final
rinses before drying.
DRYING shows on the display during the dry por-
tion of the program with the HEAT DRY option.
CLEAN shows on the display when the pro-
gram is complete or immediately after the last
rinse when AIR DRY is selected. Opening the door
or touching CANCEL clears the CLEAN indicator.
DOOR OPEN flashes on the display when the door
is unlatched during dishwasher programming or
operation. A tone will also beep twice every 3 min-
utes for up to 2 hours.