Filter
Top Products
Install properly.. .
Remove sales labels.. .
1. Allow % inch (125 cm] space on each srde and at
the top of the refrigerator for ease of installatron.
2. If the refrigerator is to be against a wall, you mrght
want to leave extra space so the door can be
opened wider
3. The refrigerator back can be flush against the wall
Level refrigerator-freezer.. .
Levetling SK4
)
Use Screwdrlver
Right to Raise;
Left to Lower
I. Remove base grille (see page 7 )
2. To raise front, turn each screw to the right.
3. To lower front, turn each screw to the left
4. Check wtth level.
Remove the Consumer Buy Guide label, tape and
any Inside labels before using the refrrgerator.
To remove any remalning glue:
1 Rub briskly with thumb to make a ball then remove
OR
2. Soak area with dishwashing detergent solution (1
teaspoon detergent In 1 quart warm water] before
removtng glue as described In step 1
DO NOT USE rubbing alcohol or flammable or
toxic solvents, such as acetone, gasoline, car-
bon tetrachloride, etc. These can damage the
material.
NOTE: DO NOT REMOVE ANY PERMANENT IN-
STRUCTION LABELS INSIDE YOUR REFRIGERATOR.
Do not remove the Tech Sheet tastened under
the refrigerator at the tront.
Clean it.. .
q P
jgiiEsqA\
\
-
Clean your refrigerator
\
before using it.
See cleaning Instructions
on page 9
Plug it in...
j-prong grounding
type wall receptacle
“9 plug
t:
1
Refrigerator
Power Cord
RECOMMENDED GROUNDING METHOD
A 115 Volt, 60 Hz, AC only 15 or 20 ampere fused
and properly grounded electrrcal supply IS re-
qurred It IS recommended that a separate circuit
serving only this appliance be provrded
Do not use an extension cord. Use a recep-
tacle which cannot be turned off with a switch
or pull chain. See individual electrlcal require-
ments and grounding Instruction sheet in your Mer-
ature package
4