Filter
Top Products
Contents
BEFOREYOUPLUGiTiN..
............
USING YOUR ICE MAKER
............
HowtheiceMakerWorks
.........
Setting the Controls
...............
Changing the Bin Door Panel
Changing the Light Bulb
..........
CLEANING AND CARING FOR YOUR
ICE MAKER
.........................
Page
Page
3
Cleaning Exterior Surfaces 6
4
Cleaning the Condenser 6
4 Cleaning the Ice Maker System. 7
4 Cleaning the Interior Components 8
5
Filtering and Treating Water 9
5 VACATION AND MOVINGCARE..
9
IF YOU NEED SERVICE OR ASSISTANCE 10
6 WHIRLPOOL ICE MAKER WARRANTY 12
cl987 Whirlpool Corporation
Before you plug it in
IMPORTANT
Before using your ice maker, you are
personally responsible for making sure that it..
l
has been installed where it is protected from
the elements.
l
is located so that the front is not blocked to
restrict incoming or discharge air flow.
l
is properly leveled.
l
is located in a well ventilated area with
temperatures above 55°F (13°C) and below
110°F (43°C). Best results are obtained
at temperatures between 70°F (21°C)
and 90°F (32°C).
l
is properly connected to a water supply and
drain.
l
is properly connected to electricity. A 115
Volt, 60 Hz., 15 amp fused electrical supply is
required. NOTE: Time delay fuse or circuit
breaker is recommended.
l
is properly electrically grounded.
l
is not operated by anyone unable to use
it properly.
l
is used only for the job it was designed to
perform.
l
is properly maintained.
NOTE: A drain pump kit (Model EKDPI) is available as an option for installation where
a floor drain is inaccessible.