Filter
Top Products
Contents
BEFOREYOUPLUGITIN..
............
USING YOUR ICE MAKER
............
How the Ice Maker Works
.........
Setting the Controls
...............
Changing the Bin Door Panel . ,
CLEANING AND CARING FOR YOUR
ICE MAKER
.........................
Cleaning Exterior Surfaces.
.......
Cleaning the Condenser
.........
Page
3
. 4
1
5
6
2
Page
Cleaning the Ice Maker System.
7
Cleaning the Interior Components.
8
Filtering and Treating Water . . . . . .
9
VACATION AND MOVING CARE. . . . . .
9
IF YOU NEED SERVICE OR ASSISTANCE
10
1. Before Calling for Assistance . . . .
10
2. If You Need Assistance . . . . . , . . .
11
3. IfYouNeedService . . . . . . . . . . . . . .
11
4. IfYouHaveaProblem . . . . . . . . . . .
11
01985 Whirlpool Corporation
Before you plug it in
IMPORTANT
Before using your ice maker, you are
personally responsible for making sure that it...
l has been installed where it is protected from
the elements.
l is located so that the front is not blocked to
restrict incoming or discharge air flow.
l is properly leveled.
l is located in a well ventilated area with
temperatures above 55°F (13°C) and below
110°F (43°C). Best results are obtained
at temperatures between 70°F (21°C)
and 90°F (32°C).
--..
l is properly connected to a water supply and
drain.
l is properly connected to electricity A 115
Volt, 60 Hz., 15 amp fused electrical supply is
required.
NOTE:
Time delay fuse or circuit
breaker is recommended.
l is properly electrically grounded.
l is not operated by anyone unable to use
it properly.
l is used only for the job it was designed to
perform.
l is properly maintained.